Excellent splash resistance tester factory? Universal testing machine (also known as tensile testing machine) that performs tensile, compression, flexure, peel, tear, shear, friction, and other types of mechanical testing in accordance with ASTM, ISO, and other industry standards. GESTER Abrasion Tester Professional manufacturer, providing a full range of solutions, Martindale Abrasion Tester in line with ASTM, ISO and other standard requirements, factory direct sales. Find even more details on https://www.gesterinstruments.com/mask-tester.
Significance and Use: Fabric Pneumatic Bursting Tester method for the determination of diaphragm bursting strength of knitted, nonwoven and woven fabrics is being used by the textile industry for the evaluation of a wide variety of end uses. universal testing machine compression test : tensile test generally involves clamping the two ends of the material sample on two fixtures separated by a certain distance. The two clamps separate and stretch the specimen at a certain speed. The change in stress on the sample is measured until the sample is destroyed. The tensile test of the tensile machine is one of the most widely used methods for studying the mechanical strength of materials, and it is necessary to use constant speed motion.
Correct use of computerized universal testing machine: Make sure all wiring is correct before the tensile testing machine is operated and preheat for at least 15 minutes to package the stability of the sensor. According to the test, the position of the upper and lower limit blocks is reasonably set to prevent the instrument from running over the stroke and causing damage to the fixture and the sample. When pressing the fast up button or the fast down button, do not put your hand between the moving beam and the fixed specimen, fixture or test device to avoid injury.
Testing to ASTM D4060 involves mounting a flat specimen to a turntable that rotates horizontally at a fixed speed. Two arms, each supporting an abrading wheel, are then lowered so that each wheel touches the surface. Before starting the test, a “suction arm” is lowered between the wheels to remove the abraded material from the sample’s surface. The turntable then starts rotating forcing rub-wear action of the wheels against the sample’s surface for the specified number of cycles or until a given mass of coating has been lost or until the wheels start exposing the substrate.
Equip with procedure time counter, digital temperature controller, auto temperature & time control, it has alarm hint while experiment ending.Can customize cup compound mode according to customers requirements. Samples Preparation: Place the samples and multi-fiber adjacent fabric under the constant temperature and humidity (temperature: 21±1℃, humidity: 65%±3%) for 4 hours. Cut 40mm*100mm specimen and multi-fiber adjacent fabric, and suture the specimen and multi-fiber adjacent fabric face to face along one short side. See extra information on gesterinstruments.com.